Requesting system reboot þestarting system. U-Boot 1.3.0.atmel.2 (Jan 27 2008 - 19:21:07) U-Boot code: 00000000 -> 00010380 data: 00016248 -> 0004c8b8 SDRAM: 32 MB at address 0x10000000 Testing SDRAM...OK malloc: Using memory from 0x11f73000 to 0x11fb3000 DMA: Using memory from 0x11f6f000 to 0x11f73000 Flash: 8 MB at address 0x00000000 DRAM Configuration: Bank #0: 10000000 32 MB In: serial Out: serial Err: serial Net: macb0, macb1 Press SPACE to abort autoboot in 1 seconds Manufacturer ID: 03 OEM/Application ID: 5344 Product name: SD02G Product Revision: 8.0 Product Serial Number: 279378205 Manufacturing Date: 07/03 SD Card detected (RCA 58916) CSD data: 00260032 5f5a83c9 3efbcfff 928040cb CSD structure version: 1.0 MMC System Spec version: 0 Card command classes: 5f5 Read block length: 1024 Supports partial reads Write block length: 1024 Does not support partial writes Supports group WP: 32 Card capacity: 2032664576 bytes File format: 0/0 Write protection: mmc: Using 131072 cycles data timeout (DTOR=0x62) ............................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................. 1167370 bytes read ## Booting image at 10200000 ... Image Name: Linux-2.6.23 Image Type: AVR32 Linux Kernel Image (gzip compressed) Data Size: 1167306 Bytes = 1.1 MB Load Address: 10000000 Entry Point: 90000000 Verifying Checksum ... OK Uncompressing Kernel Image ... OK Starting kernel at 90000000 (params at 11f73008)... Linux version 2.6.23 (hcegtvedt@hcegtvedt) (gcc version 4.2.1-atmel.1.0.3) #1 Thu Dec 13 17:05:06 CET 2007 CPU: AP7000 [01] revision 0 (AVR32B revision 1) CPU: MMU configuration: Shared TLB CPU: features: dsp simd ocd perfctr java CPU: Running at 140.000 MHz Physical memory: 10000000-11ffffff Reserved memory: 10000000-1016ae5d: Kernel code 1016ae5e-101f8767: Kernel data Exception vectors start at 90011000 CPU: Paging enabled Node 0: start_pfn = 0x10000, low = 0x12000 Node 0: mem_map starts at 901fb000 Built 1 zonelists in Zone order. Total pages: 8128 Kernel command line: console=ttyS0 root=/dev/mmcblk0p1 rw rootwait PID hash table entries: 128 (order: 7, 512 bytes) timer: AT32AP system timer/counter at 0xfff00c00 irq 22 console [ttyS0] enabled Dentry cache hash table entries: 4096 (order: 2, 16384 bytes) Inode-cache hash table entries: 2048 (order: 1, 8192 bytes) Memory: 30460k/30460k available (1383k kernel code, 2308k reserved, 106k data, 68k init) SLUB: Genslabs=20, HWalign=32, Order=0-1, MinObjects=4, CPUs=1, Nodes=1 Calibrating delay using timer specific routine.. 280.49 BogoMIPS (lpj=560985) Mount-cache hash table entries: 512 NET: Registered protocol family 16 pdc pdc.0: Atmel Peripheral DMA Controller enabled at32_eic at32_eic.0: External Interrupt Controller at 0xfff00100, IRQ 19 at32_eic at32_eic.0: Handling 4 external IRQs, starting with IRQ 64 smc smc.0: Atmel Static Memory Controller at 0xfff03400 Generic PHY: Registered new driver dmac0: DesignWare DMA controller at 0xff200000 irq 2 Time: avr32 clocksource has been installed. NET: Registered protocol family 2 IP route cache hash table entries: 1024 (order: 0, 4096 bytes) TCP established hash table entries: 1024 (order: 1, 8192 bytes) TCP bind hash table entries: 1024 (order: 0, 4096 bytes) TCP: Hash tables configured (established 1024 bind 1024) TCP reno registered audit: initializing netlink socket (disabled) audit(1167609600.303:1): initialized JFFS2 version 2.2. (NAND) © 2001-2006 Red Hat, Inc. io scheduler noop registered io scheduler cfq registered (default) atmel_usart.0: ttyS0 at MMIO 0xffe01000 (irq = 7) is a ATMEL_SERIAL MACB_mii_bus: probed eth0: Atmel MACB at 0xfff01800 irq 25 (00:04:25:1c:55:6c) eth0: attached PHY driver [Generic PHY] (mii_bus:phy_addr=0:01, irq=-1) MACB_mii_bus: probed eth1: Atmel MACB at 0xfff01c00 irq 26 (00:04:25:1c:55:6d) eth1: attached PHY driver [Generic PHY] (mii_bus:phy_addr=1:03, irq=-1) physmap platform flash device: 00800000 at 00000000 physmap-flash.0: Found 1 x16 devices at 0x0 in 16-bit bank Amd/Fujitsu Extended Query Table at 0x0041 number of CFI chips: 1 cfi_cmdset_0002: Disabling erase-suspend-program due to code brokenness. RedBoot partition parsing not available Using physmap partition information Creating 3 MTD partitions on "physmap-flash.0": 0x00000000-0x00020000 : "u-boot" 0x00020000-0x007f0000 : "root" 0x007f0000-0x00800000 : "env" atmel_spi atmel_spi.0: Atmel SPI Controller at 0xffe00000 (irq 3) mtd_dataflash spi0.0: AT45DB642x (8448 KBytes) atmel_usba_udc atmel_usba_udc.0: MMIO registers at 0xfff03000 mapped at fff03000 atmel_usba_udc atmel_usba_udc.0: FIFO at 0xff300000 mapped at ff300000 at32ap700x_rtc at32ap700x_rtc.0: rtc core: registered at32ap700x_rtc as rtc0 at32ap700x_rtc at32ap700x_rtc.0: Atmel RTC for AT32AP700x at fff00080 irq 21 at32_wdt at32_wdt.0: AT32AP700X WDT at 0xfff000b0, timeout 2 sec (nowayout=0) mmc_host mmc0: Atmel MCI controller at 0xfff02400 irq 28 Registered led device: sys Registered led device: a Registered led device: b TCP cubic registered Initializing XFRM netlink socket NET: Registered protocol family 1 NET: Registered protocol family 10 IPv6 over IPv4 tunneling driver NET: Registered protocol family 17 NET: Registered protocol family 15 at32ap700x_rtc at32ap700x_rtc.0: setting the system clock to 1970-01-01 01:10:39 (4239) Waiting for root device /dev/mmcblk0p1... mmc0: new SD card at address e624 mmcblk0: mmc0:e624 SD02G 1985024KiB mmcblk0: p1 EXT2-fs warning: mounting unchecked fs, running e2fsck is recommended VFS: Mounted root (ext2 filesystem). Freeing init memory: 68K (90000000 - 90011000) Mounting virtual filesystems: /proc mounted /sys mounted /dev mounted /dev/pts directory made /dev/pts mounted /dev/shm directory made /config mounted /tmp mounted /var/run mounted /var/log mounted Setting up mdev: done Setting hostname: 'ngw.example.net' Starting syslogd: done Log messages to syslog: done Starting klogd: done Probing modules: Mounting local filesystems: done Network interfaces: udhcpc (v1.7.2) started Could not receive return value from daemon process. Sending discover... Sending select for 192.168.2.107... Lease of 192.168.2.107 obtained, lease time 21600 Failed to kill daemon: No such file or directory deleting routers route: SIOCDELRT: No such process adding dns 192.168.2.1 done Starting dnsmasq: done Starting telnetd: done Starting inetd: done Starting ntpdate: 9 Feb 11:57:33 ntpdate[212]: step time server 131.234.137.24 offset 1202557608.552596 sec done Mounting remote filesystems: done Starting dropbear sshd: OK NGW100 ready BusyBox v1.7.2 (2007-12-13 16:51:33 CET) built-in shell (ash) Enter 'help' for a list of built-in commands. #